Ports Description

The E-SBC module provides various port interfaces as shown in the following figure and described in the subsequent table.

E-SBC Module Ports

E-SBC Module Ports Description

Item #

Label

Description

Reset pinhole button:

■

To reset the device: Press and hold the button for up to 5 seconds (and not more).

■

To reset the device to factory defaults: Press the button for at least 15 seconds, but not more than 20 seconds.

IOIO

RS-232 port for serial communication with a computer.

Pinhole button (reserved for future use).

Handle of AMC module for installing and removing the module.

LAN sub-module, providing eight, 1000Base-T (Gigabit) Ethernet ports for connecting to the IP network. The Ethernet ports operate in pairs, where one port is active and the other standby, providing 1+1 Ethernet redundancy. These ports support half- and full-duplex modes, auto-negotiation, straight-through and crossover cable detection.